Roof Razor® Insulation Spacers 115mm C3 (Cyclonic) – Pack of 6

$287.88 per pack of 6 (incl GST)

SKU: RRZCIS115GA Category:

Roof Razor® insulation spacer is engineered to minimise the amount of compressed blanket atop the purlin in commercial roof construction, as the innovative design cuts through the blanket like a razor, allowing full recovery of the insulation between the safety wire mesh and metal roof sheeting.

  • Roof Razor® Cyclonic is equipped with an extra batten insert to increase the fastener yield capacity, and is pre-loaded with 6 x 14 gauge 10TPI class 4 fasteners.
  • Available 1200mm long in packs of 6 (7.2 lm coverage)
  • 115mm high spacers to suit insulation blankets 130-145mm thick
  • Ideal solution to satisfy NCC, Section J Energy Efficiency requirements
  • Boasts an impressive national reputation built on ease and speed of installation
  • Seamless compatibility with all relevant insulation blankets and roof cladding profiles
  • Suitable for use on roofs with a pitch up to and including 30 degrees
  • Wide and stable enough to walk and balance on – may be trafficked the same as a purlin
  • Supplied pre-loaded with screws for rapid installation
  • 1200mm length to match typical Permastop® Building Blanket width, allowing for a direct line of sight to the purlin
  • Incorporates an overlapping tab which specifies where to position the consecutive spacer
  • Cuts through insulation to give a direct connection to the purlin, ensuring that over time the bracket will not loosen as a result of vibration and movement
  • Australian made